CrossThread Customs

Alright guys, we're going to pull this seat gas tank. We'll make sure this is off. This gas tank has amount to the petcock down here on the frame on these so you've got to remember to take that off just to make it easier. There's a couple plugs, we're going to undo that. But yeah, we're going to get into this. I So that's always fun. Always have somewhere to set your shit. Parts that you take off the bike, usually I have a shelf that I stack everything on, but again, I decided to take it down and put it up in the attic because it seems to work a lot better up there. And then I can just scatter parts all over the shop just I always put these in here, I'll joking aside. 8mm, 10mm, depending on what you're doing, disconnect the battery. I don'think it's necessary for the clutch cable. It may seem Just take the tank off, it only takes a few minutes to do it right. A little rubber elastic has a hook. This is a dust guard, this is probably supposed to be up I don't know. Keep all your hardware in one spot. I also have an extension so you can just spin these. Some people I feel like there's more risk with impacts when you have al It's going to be a little more cautious. Definitely something It's always good to have a place to set it before you remove it from the bike. I'll probably just sit on the ground because it's probably going to go right back on. Make sure fuel is off. You'll probably pull the fuel line off right there and it'll do it before we undo the bolt so you're not having to hold it. Fuel will come out of the line, get gloves on or paper towel or little fuel is not going to hurt your hand, but 35 years of it.