Big Worm Graphix

Got my graphics in today from Big Worm Graphics. I went with white stripes so I'm not gonna do the over-the-top sections right now. I'm just gonna do the side stripes so fender, door, and rear quarter. The stripes are labeled driver, passenger, so you're not gonna screw that up. They're all pre-cut nice so that way they're supposed to be perfect fit so to speak. They will wrap the end of the door just for a seamless look. So first I cleaned all of this rocker molding area with Windex and a microfiber. I went over it twice. I have a bottle here filled with water. They do include a squeegee with a little felt on the end so you don't scratch the stripe. They do recommend spraying water but not soaking the hell out of it. On the backside of the stripes and on the face of the stripe on the white paper. They do give you full blown instructions so It's in color, typed out nice so just gonna follow that. I've done this before so it's not rocket science to me. It's just you got to take your time. Measure, use masking tape to hold the stripe Make sure you don't make any mistakes so I'm gonna start with the passenger side first. Alright so here's the fender done. I just got to open the door and stick it a little bit better to the inside edge there. What a nightmare though. You got to be very careful this inline very skinny pinstripe for the GT500. It does not come off nice off of this backing so it actually split on me on the last zero and 500 so I had to manually put the little insert in and the square. You got to use a ton of water and patience and a lot of the F words and it eventually straightens itself back out so that's what I just did. Now I'm just gonna get the inside edge of this and then the front fender is done. I'm gonna let it try move on to the next stuff which is the door here. It won't hurt to use This is usually the most common places where this stuff peels is on the edges so as long as you got it clean and nice you may need to use a little heat but should straighten yourself right back out. you so I'm not sure how many people this will help but when you strike the shellbees you have to take off the HELB off the back my S-Stade so what I did was take a piece of masking tape now remember the trunk lid is not dead not straight so I just put tape under the S and ran it all the way over to beneath the Y so that is usually good enough for me and then from the S I put the tape measure right against the S from the S to the H to the first part of the H