Badger Plasma Cutting

What's going on everyone I don't know much more about it than that I don't really need a better definition than that all I know is that it cuts metal and it works really well So t I haven'tried to cut anyt It's easy to use. It's easy to handle It's easy to set up so basically you plug air into it set your regulator Plug in the electrical cord and your cutting metal my only complaint about t It's rather thin I'd like to have something a little bit more heavy-duty I feel like if I were to accidentally You can switch between 110 or 220 volt and I haven't used it yet on 220 volt, but we'll see how it does So what I'm gonna do right now is I'm gonna flip on the machine Show you the regulator setting and then I'm gonna hold the torch up in front of the GoPro and show you guys what the plasma torch actually looks So Sam at 75 pounds I'll show you what the arc looks like real quick So what you also hear right now is the post flow lasts about 15 to 20 seconds And the reason for that is to help cool the torch after you're done cutting All right, so a little bit more about the machine like I said, this is a Miller spectr That's how it works. I've been using it mainly for sheet metal So what I'm gonna do So I've been making You're gonna have to clean up your edges also on this machine It has a high frequency start some machines you have to actually touch to start your arc This has a high frequency start so when you get close enough to metal It'll make an electrical connection and then you can start cutting Also, you do not drag the tip across the metal like this You want to keep a distance of about the thickness of your material that you're cutting Because if you start touching the material what it does is it g I spent about a half hour on it the other day Just getting a feel for the machine And I've been trying to be careful about how I cut because there'some floor braces and stuff that I want to leave in here But what I'm gonna do is I'm just gonna cut this panel out real quick just a small piece So that I'm working on the front floorboard. I Have my ground in the back on the little X brace that goes be No problem I guess that this plasma cutter will do three eights So that's gonna do it for my quick little review of the Miller plasma cutter the spectrum 375 So far, I'm really happy with it If you guys are looking for something for home use even if you're looking for shop use like duty This is a great machine to work with and now that I have hooked up to 220 It's actually cutting a lot better So if you have the ability I'd hook it up to 220 and go that route if you guys have any questions Be sure that you comment below and I'll be sure to answer them for you and as always if you guys are new to the channel I sell merchandise for the channel high psik TV There's always a link in the description below and you can also check me out on Instagram I'll put my name up here so that you guys can see it for those of you who follow the channel I'll have another one for