Crown Carbon Crafting

Today I'm going to show We've been getting a lot of questions about how to install it, All you're going to need is a tape measure, a box cutter or anyt That's it guys. Alright, so if you flip t So you're going to get your pointy object and all you're going to do is flip one of the corners one side Don't pull it all the way off though, just crease it. Now we're going to do the same to the other side of the 3M. Peel that one back about two inches and crease it. Now that's done, we can move on to our next step. Our next step, we want to make sure that our surface is really, really clean for proper adhesion. So you want to spray our cleaner. So the 3M is going to go on t So make sure you clean that thoroughly. Now that your surface is clean and dry, you want to bring up your wing to it. You want to start off on t Make sure your 3M tape is pulled out from there and from there. Once you line it up, do not put pressure on it. So you want to tuck t So now that you have it mocked up, before you pull out your 3M tape cover, you want to come over here and use your tape measure. Okay, so for our next step, we're going to use our tape measure. Our tape measure, we're going to measure from the edge of the trunk to the corner of the wing. We have two corners on either side of t So that's going to tell us if our wing is level or not. So we got 8 inches here and 8 inches here. Now that's me know that t Okay, now that our wing is level, we can now move to our next step. We're going to start off with t We get the edge and we start peeling it very softly, very gently. Do not apply pressure just yet or else you're going to pinch your tape and it's going to rip. I normally Do not put pressure over here or else you're going to pinch your 3M tape cover. From there, you want to keep going up to about that point. I normally In t So now we go back and we put more pressure. Make sure it's nice and taped up right there. But Take off the rest of it and then put pressure on the remaining edge. For our final step, we want to start peeling our 3M tape cover. We can start inch by inch and You can go up to about there and then from there, we can start applying a little pressure starting from t Remember, you do not want to get too close to the 3M cover because you do not want to pinch it. Once that's done, we can now move on. Once we get to that point, we can go ahead and start putting pressure on t Just Now that we're done with the 3M cover, we can put pressure on the whole t Now you just clean it up and call it a day.