Service and repair on all Harley Davidson Motorcycles.Dyno tuning and testing.
Located behind JMJ Motors.
Okay, so I ordered the Macomb County Chopper's Fat Clutch push rod from my 2017 Rogue I've already removed the clutch inspection cover or the derby cover and just put a rag here to kind of keep it from stuff getting in there. Because I took it off last night and I didn't have a torque wrench so I had to go get a torque wrench. And the special plier to take off the snap ring that goes in there. So now I just have to take this off. I've seen many YouTube videos on this and so since I'm an aircraft mechanic I didn't feel that it was that hard. This is what the fat rod looks So that's what I'll be replacing right in there. Because the first thing is we have to take off the snap ring right there. You'll see where there's a hole right there. And another hole right there. Okay, so I'm going to take that off. Once we remove that dipane ring then this right here should just come out. Just Keep it together. And then this push rod should just come right out of there. Just Now I'making a difference in which way it goes in. So the one on the right is the fat push rod and the one on the left is the OEM. Apparently some of the oil transfer that's happening between the transmission and the primary is going through that tube. Because the OEM rod is not picking up to block some of that space. So Here we go. I'm going to put it back, put it in. I'm going to rub a little bit of primary fluid on it. It's going in. Make sure it's going in. Then I'm just going to put it back in the way it came out. And then turn the engine and this is the primary engine. Just rub a little bit of a particular way that it goes in. You can feel it. So I'm just going to make sure that it's not going to go around. Once you place the thing in, you'll see that the spool will close it up. Put the baby cover or the participation cover back on. And put the bolts, put the carabiner, and then you're going to press cross on the counter. And then you're going to turn it into an H-Pix. So I've set the total points to 100 inch pounds. And then I'm going to go first pass time up here, then here. Okay, well that's your torque. That's it. You clean up and you get to go.
