BackYard Creations

Hello and thank you for purchasing your backyard creations dining table. This is your assembly of video. For the assembly, your table is going to become pre-mounted in the rim. The materials that are going to be with it are a smaller ring, four legs with a hardware already attached, four plastic mounting clips, four Phillips head tech screws, and Allen key. You will need a Phillips head screwdriver. First, what you are going to want to do is make sure that your lower ring is face down and how you can tell is you will have your drain holes face up. The other thing you want to make sure of too is when the legs come that you have two b On the leg, this is your top, this is your bottom, you can tell because the bottom has the glide to it. The first thing to mount the leg is you are going to want to take the hardware onto the leg. This is just one bolt, Allen bolt, with a lock washer on it. Your ring is already upside down, your leg is upside down. You are going to line the four holes up with each one of those holes on each one of the four legs. There is a little hook right here. You just want to gently hook it in and hold it. Grab your screwdriver, it is a little trick and this will help you to indicate your hold. Once you have that, take the screwdriver out and snap it in. Grab your Allen screw and start threading the ring. Then you can take your Allen key and you don't want to tighten it all the way. You just want to tighten it so almost all the threads are all the way down. It is just a little easier for the later assembly. These are all four legs on your base. This is upside right so you can have an example where your b Now you are just going to flip it over, put it in the rim. The ends of these just avoid the nylon stops in the rim. If any of them are sticking out If any of them, this is very important, aren'touching the rim, you can just pull it out of the rim. Give it a push on the foot side and a pull on the table top side. It will bend right out. You are not going to hurt or break anything at all. I am going to come around and show you. On this side here, you should be able to see it good. Again, bring it up over the table rim, push on the foot, and pull on the table top side. You can do all four legs if need be. Once you do that, you can put it back in the rim. Now you can see even the two over here aren'touching so now you can just push it right at the back. Drop it in. Push it right at the bend, drop it in. Now you have no space between the rim and the edge of the leg. Once you complete that, you are going to grab your nylon mounting hardware. Now, you are going to have a peak one side and a hook on the other. There is a little gully on this rim here where the hook is going to hook into and the peak is going to be phased down. There are pre-drilled holes on the legs where your Phillips tech screw is going to go. They line right up. Again, hook and a little gully or alley or whatever you want to call it. Grab your screw, put it through the hole. It should line up with the pre-drilled hole, no problem. You are going to have to give a little down pressure just to get the threads going. Don't be afraid of it, you are not going to hurt anything. There you have it. This is your Co-Pleaded Backyard Creation Table.