Acabados Profesionales En Madera

Today we are going to see how we can leave some doors practically perfect. So we are going to need a silicone gun and a wood sealer. What we are going to do is cover the joints between the door and the hamlet. This line that sometimes looks ugly and is filled with dirt, we are going to level it. As the sealer cord is going to reach us here, we are going to bother the sealer. So we are going to remove it. Only remove the two screws and it comes out. We take the wood sealer. The movement has to be uniform and the pressure you have to exert is more or less the same. To distribute it, the same technique as with the silicone. Water with a little soap, you put your finger a little and you pass it from one pass all over. If you have any retouch at the end and others, you pass it in the opposite direction. There are corners that are a little more complicated, that you are going to have to do is to give it to one side and to the other. That in other ways you will see it. As you go in, you see where you need it. And that in all the parts that join the door with the hamlet. To leave it as if it were from a piece. For all the doors you can use wood sealer. But for the bathroom I recommend white silicone for the issue of h And if you have any challenge that, from a nail tip that has been left a little bit out and others. Keep watching the video, I'll explain how to place it. We place the sealer again. If you have any questions or suggestions, you can leave it below in the comments. These are the commercial voters. So this piece what it does is that it introduces the nail inside the wood without marking the outside. If you don't have this, you can use a nail. These nails have to be completely correct. You don't use nails used or neapolite style. When you hit the nail, the body has to be completely correct. You take a nail, you support it against a nail or another hammer, the bottom part. And on the top part you hit with another hammer. So that the tip gets a little bit in place. Just so that you have more or less the size of the nail you want to put in. Or I'm going to do a test. We have here two holes So what we're going to do is put the nail inside, it's a dry hit and the nail has to be completely correct. If you don't, you mark it as I just did. And the other one is a nail that doesn't have a nail so you can see how it looks with the nail. We give it a little bit of nail polish, we distribute it with the finger previously in water with soap. I use the circular technique for this type of hole because at the end it covers it very well. See? If you And if you want to see more videos, subscribe and hit the bell so you get the notifications.