Pops Workshop

I showed you around the shop a little bit, but I wanted to show t So I'm going to turn it around and one of the t And then the hose I've got connected into these here, these are blast gates. So I can open up this and close it down, but that's connected into the central hose vacu I have another outlet over here. And as I'm at each workstation, t And these were cheap actually. They were T Or if I want to do somet But if you look at the back, you can see I've got that connected to, I got some, t It's not, And I said I don't need that, t So it's two and a half inch, but I got, it's flexible hose and that ties in over to here. And then I got to go around the water heater and it connects up there and then over to here, w But the hose t So the table saw goes down here and I've got a piece on the table saw, w I fas And I made t I fas And then I connect into the hose here. And that's a zero, zero clearance plate I put on to that again, so that I could do nice tight cuts. But continue on with the dust collector system on the other side of the furnace. T And then t I can use it for, t And then I've got my drill press. And then I also have my four inch belt sander with a six inch disc sander on it. So I can kind of keep it pretty clean. And the actual dust collector, what I was using before, I used to just have a shop vac. And the shop vac was good. It sucked good, but it was noisy as hell. And also, So I figured I would incorporate some kind of, and t I made these fittings to these here are made out of PVC. But t What is t I made out of buckets. It's a two stage type t And it collects all the big dust particles in there. As you can see, I've got them with attaches with the switch and then the whole bucket comes out and I can take the dust out. It's kind of be filled, not emptied out a little bit now. But I've got the actual vacu And on the other side, I put the actual vacu And I also did a dedicated switch first so I could easily switch it on. And on the other side of the wall, I don't know if there's enough light. I don't have extra light in here. But on t I mean the shop vac. So then I clean t But all the big particles and stuff collecting the bottom bucket down here. So I'm pretty happy with it. It seems to work out well. And so I made a couple of jigs for use with different tools and I'll show you some work as I progress. Okay, I love See you. Bye.