Designcovers

Okay, so we're going to install the bottom seat of the seat cover for an RV. So this is what it's going to look And then when you flip it over, we're going to have a couple buckles here that we're going to go push in between the seat. Now t On some RVs that we've installed, there's actually a final webbing there that won't allow you to push these through. So you would have to make an incision where you can pop these buckles through because eventually the ones from the front are going to be pulled underneath and tightened with the ones that are in the middle. So you guys see what it looks So t It's going to tighten up with the ones in the middle so we can tighten that seat down and make sure that it's nice and snug. Push these guys through here, and then a little seat. Push t Get these straps, and we're going to snap t You want to try to make sure that t So it does take a little bit of time. You're going to have to go underneath. Really, There's going to be some brackets, some metal bars. You kind of just have to slide t Not a whole lot of space. Just going to have to work it little by little. Alright, we've clicked it tight. Now I'm going to grab the concept, t Put up the Velcro. The biggest part is if we want to stuff t All RVs is going to be the same, very similar concept. So even though t Put the armrest. T Same t I'm going to work that down a little bit. Just get it a little bit tight in here so you just want to go back and forth. And the other t Little areas where it's not super tight, so just know that might be the foam in your seat. So you got t And You want to put t It'll pull the top of that down a little bit. Okay, so now we've got the sides here. Make sure that stuff is down. Pull that in. You want to line that Velcro. Make sure that kind of lines up there. Okay, so now we're going to go ahead and find the strap underneath. And you want to pull t Nice and tight. So that'll kind of pull the middle of the seat down to hug your seat. All right, so that's pretty much that. Now we'll do an armrest. So the key with the armrest is, kind of want to fold t So t Again, it's a lot easier if these are a little bit warm, so it's easier to work with that material. Here in California, we get a lot of suns Some areas in the country, it's obviously ideal weather all the time. But t Make sure that the top is on nice and tight. And we just kind of make sure everyt . . I'm going to pull t And then once it's on, you can still kind of work it a little bit. Make it look That's it. Okay, whenever there's a lever Normally we make an opening, but you're not going to get a clean look. So you definitely want to take t So you can put a little help, actually help secure the seat cover a lot better as well. And then you want to pop t And what we're going to do is, we're going to line the seat up, make sure everyt Obviously you want to make sure you don't. . . You want to be careful because you don't want to cut your finger. So once you do that, you'll go a little bit bigger. So what you want to do is to make sure it doesn't run. You want to cut a little X. Get some sharp scissors. Okay. And you'll see the nice finish once we get that done. Let's pop the lever back on, A little bit nicer look Okay. And t . . This will wear a little bit better once we sit in it for a while, and it'll look as neatly But that's a nicer finish than we would have tried to do a cut out on that. Okay. So that's the way we do that. All right. Okay.