New hours, call before stopping out - New Phone Hours M-F 9-5 est.
Michael Johnson - Owner- Fabricator-Mechanic Ron Franklin - Painter - Auto Body - Detailer Austin Schumacher - R&D Tech Andrew Ducey - R&D Tech Leo Swithenbank - Public Relations Taylor Singleton - Public Relations Kyle McGrew - Accounting Kyle Deyoung - Head Fabricator - West Coast Contact Nathan Linderkamp - Head Tuner Josh Broaddus - Apprentice
As you can see the throttle body is installed and the cord is actually on this side We're on the other one at point on the bottom here But the NA cable is long enough just plug right in we don't need an extension on it So it fits right on I'll get some more things done for the install verify everything And then I'll get it running here in a few minutes. I hope you all keep paying attention And like some of you guys on the for We're still gonna try to have one made that's gonna flow better But this is with the old one you throw some oil inside of it I used a bigger clamp because you said the other clamps are gonna work grease it up and wedged it on there So we'll get the air box in and we'll get it fired up and see how it sounds All right, everything's installed don't mind all the dirt. I say this is the nasty we've been out muddin in it Ain'that time to wash it yet, but we're throwing fired up and see how it sounds I Running the cold so maybe have a little warm up time I wish you should so they kept pretty good On the gravel seems to break loose a lot easier It Picks up real good down the gravel so that the throttle response is better gains I wouldn't know I'm not gonna dino yet because Everything's running good. No issues yet. No idle issues So we stop I was down just fine holding good solid. I don't know fluctuations. So I'd say it's pretty much plug-and-play Thank you the new throttle body everything I only fine. So there you have it guys No problems at all so far. We'll plug and play and I hope you have fun with them