MyDealerSupply.com

I'm Keith Pal Depending on the quantity you purchase, you'll receive either a box or a shrink wrap pallet. Inside your box, you'll receive your foam, instruction manual, custom cut tops, tough flat clips, and your pole-tector rings. Note if you have a logo that covers two rings, it'll be taped together with some blue painter's tape. Make sure you keep those rings together so they line up correctly. When installing your pole-tector, it's important to make sure that the ground is level. When you have grass or dirt, we use a flat iron bar and we just cut around the outside of the base. Starting with the first ring, if you take your two half rings, w You hear a little snap, very easy. It's important to snap one side before you wrap it, otherwise you're going to have to take it apart. If you do, as simple as putting a flat-head screwdriver inside t Put it around your pole-tector and snap again. Buckle, buckle, slide it down. Then you'll grab your foam and depending on the t It's important to keep the bottom ring level to ensure easy installation. For the second ring, you'll snap the back. They all snap the same way. You'll snap it around the pole, buckle it here. If you notice on the pole-tector, they all have a male part and a female top. Then you're going to have a bottom, kind of a male portion and a female portion on top here. The male always is going to be on the bottom. It will set. Go right into these female grooves here on the ring, w So we'll line the right one up, tap it in and you'll see it come through. Once that is, everyt Give it a little tap of the back of your hand and you'll see that the actual prongs go through buckle inside the winder level. Get a nice, tight seam. Grab a second piece of foam. Same as the first. Just around. Grab my next ring, buckle it. On t So to make sure that the bottom part is here, start with my male side, knocking in t It's important if you have a logo that stretches over two, that they line up. That's why we put the tape on them. Make sure you keep those together. So make sure that the male part here, I'll put a little weight. You'll see it come right through the top side. Then you just work it around. Now your rings are ready for the top. Now for the top. It's very simple. It's again a buckle system. There's kind of a little bit of a trick to it that you'll find after you do a couple of them, but basically the slide in there. I put pressure under it and a little on the then you just snap in together and you'll feel it go. Spin it around. T Snap together. The last step is you'll take your bag of Tough Lock clips, singles, and you'll notice that you hear a pop when they're correct. You also know they're correct when they side to side. Another single. There's going to be two sets of doubles that actually go between the two halves that help hold it together. The doubles snap in just Make your way around. Make sure that the lid's on. If you notice here, there's a little bit where the lid is a little farther out in the base. Again, the barb's facing you. You almost use it as a lever and just pull the pulltector back towards you and you hear it snap in. The same over here. Just push it and it'snapped in. Normally you won't need to cut. We notice on t We just took a pair of 10 snips and cut it out of the tab. Just mark it here where I want to do it. It's very simple. Just make a straight line. The pulltector when it's completed, it's good for protection. We're enhancing and branding. We'll look forward to covering your bases.