Battery Viking

Here we're going to talk a little bit about preparing your Motobot battery for installation and replacement of a typical flooded battery type. Here as we can see the batteries are obviously very similar in size. T So first of all you'll notice that the MB9U with the spacers on is a little bit taller than your old battery. To fix that you basically remove the spacers, discard the one that you don't need, install the one you need, now you have the same height. And we look at the terminal location to see if we have positive to positive, negative to negative. From there we actually remove the protective terminal caps. With that said we take the terminal, the Motobot battery of course comes with the terminals, comes with the screws, comes with the wrench to install it. We basically take the brass terminals and the stainless steel fasteners so we install the terminal t But in t If you did have a battery that had a side access requirement then you can put the other terminal on the button terminals actually on t From here you install the terminal the same way on the other side, attach your cables to the front once it's in the bike and you'ready to go.