Powerhaus VW

I know it's been a little while since we've done any YouTube videos. We've been running behind on some of these engine builds, so we've been in the shop just trying to get them built, get them shipped out, so we haven't had much time to do any videos. But we really appreciate all your patience. All the customers have been real patient for us, and we're catching up quickly, so we wanted to say thank you. This motor is for Alfred Sheffield. It's a 2332, and it puts out about 175 to 175 horsepower slash torque. We build our motors square, so they make about the same torque and horsepower, and they make nice low end drivable power. This motor is running our traditional al This particular one has an MP crank and rods, but They work really well. This also has the CNC ported MP cylinder heads, 4237 L6 port, MST billet valve covers. Of course we use the stainless A1 side winder exhaust system. This has the dual tip outlet, the Bernie Bergman port shroud, dual 44 webers, and then we have the Magnus Park distributor from CV Performance. This is their distributor setup. It comes with a coil, which we have underneath the shroud, and then we modify their wires with 90 degree boots down here at the ends, so that it fits and just looks real clean. This thing's already been started up, it's been dialed in, we did the first service on it, just the valves, check everything over. We're going to run it one more time, put it under a load, and then I'll drain all the fluids, we'll box it up and get it shipped out. Alfred, thank you for choosing us to build your new motor. I can't wait till you get this. Keep us updated, maybe send us pictures when you get it installed, and keep us updated, but again, thank you for choosing us to build your motor. We appreciate that.