Graphics RV

We're here installing some grap Wanted to show you how we put them on when you can't split them up into pieces. It's one shot. First t I'm going to mark it with a pin. I did it, folded it, creased it. I'm going to mark it. Okay. Next t Using these magnets. Just keeping it in the hole for myself. You can also use tape. Does the same t Some of the newer vehicles like the Ford F-150, they are al You can't use the magnets, so we'll just show you with tape. For each ve I know based off that's all I'm going to work with. I'm going to lower it down. A few t I always use two pieces of tape. No more. You don't want three pieces. You need to be on the move on the wheel. So now that I've moved up my center is off, so I need to slide it over a little bit. Next t I measure up and down. Way too When I measure, I'm finding two points that are similar. I'd go off t If I had curved letters, I'd find a curved letter. And Now I've got it straight. Normally what I show is that we tape it all the way across here. Then we come through and we cut sections. But the issue we got here is that t So I can't divide into pieces. So I've got to come from one side or the other. I So what I'm doing here is I will Can you give me some scissors? So I'm removing about a t I take then I crease it. Okay. Got to have a squeegee. Sometimes you need two people. So all I'm doing is trying to get it flat and straight so it looks very smooth. So I'll squeegee with a little pressure. T I never squeegee right up. I usually leave it out. That way I can come back through here. Pull up some more and see what I've got. So over here on the edge, put a little bit of tape. That way I know t So again, I've got to So I'm just pulling. I'm not going to pull all the way off. But now, I'm going to work it all the way across. Notice how I have it up off. I'm not real close. And I won't come all the way off until I get closer to the edge. Okay. Trick to pulling and lettering the tape, what we call transfer tape, w You want to pull down t If you're pulling out, you're going to pull off the ve If you're pulling down, then less So you don't want to go super fast doing t Maybe the vehicle is a little bit cooler than you'd Maybe the vinyl doesn't adhere as well to start with. On this vehicle, this stuff sticks So a good way to know if it's going to stick well to your ve If the tape sticks really well, If the tape is not wanting to stay, then It's critical that you install it in a temperature that's 60 or above. The ve Makes t Now in t So that's why there's two layers of tape here. Most grap So they got to put one piece. If it's really large, then we try to divide it up and make it easy for you. All right, then you go through and you want to look to make sure you have no bubbles. It's pretty common for people who don't do they could have a lot of bubbles. Little bubbles you don't want to worry about. It's the bigger ones You want to zoom into that brand and if you can see that real well or not. You just want to pop it. If it's little bubbles, they'll be gone in a month. It's the way t I'm going to come through, cut everyt As far as a little different soil wrap it around the back side, it's not going to go into that part real well. So we're going to try to just press down. Then the last step, just go back over it. When you're pulling the tape off, you tend to be wanting to pull it up so it may come up just a little bit. Go back over it. Make sure you get it real well. You will notice that I've got two different squeegees. I've got one that's got a felt tip on both sides and I've got one that's got a hard side. The felt side is nice. These are quite a bit more expensive squeegees. We send out a normal squeegee that's got just a rough edge. It would work just fine for doing t