All mechanical and electrical
Okay, t I got to get somet These are phase separators. T We're going to go over one, two, three, four, five, six, seven, eight. Seven slots, six slots. Separation would be 60 degrees for the second phase. So, there we go. These three slots, these three slots for the first pole on the second phase. T I got t B start, I got my 12 wires in hand. I got all t Slide one stick, t Kind of use a stick as a marker. Don't put it in all the way because I know I'm going to put one more turn in it. I'm going to put it in the middle of the second pole. I'm going to put it in the middle of the second pole. T Now up here we're going to j I'm always going to make sure you do the same rotation on all the phases. Now j Now we go over to a new slot here. That's going to finish that's going to be the second turn. Second turn. I'm going to put the stick all the way in for now until the last phase. Now new slot. New slot down here. J Now we're going to finish t Now we're going to put the stick in the middle of the second pole. Now we're going to put the stick in the middle of the second pole. That's the first pole second phase is in there. The next pole covers one, two, three, skip three, and the t Skip three and these. We need to go all the way over to the last slot. Last slot second pole. That's where the j We need to get the phase insulation. T It's just a 333 paper. I'm going to put the tape in the middle of the second pole. I'm going to put some air in my tighter w I'm going to put the tape in the middle of the second pole. I'm going to put the tape in the middle of the second pole.
