Leaders not the followers in Custom Bagger Parts. Your one stop shop for Custom parts, accessories and assembly.
Leaders not the followers in custom Bagger Parts: Stretched bags, fenders, and Tanks. Custom fairings, lights, dash panels, spoilers, side covers, Air ride kits, Floor Boards, Handle Bars, Bag liners, custom frame work, oversize front tire kits and assembly, painting etc. Your one stop shop for Custom parts, accessories and assembly.
Okay, here we go. Lessons on putting on side covers, w Here we got our 97 Ultra Classic. Actually, kind of pre-drill the holes already. But basically what you want to do is you want to just fit your side cover on where you want to put it. Just want to line it up. Make sure it's real nice. Make sure your sides are all flat and everyt Check your lines. Make sure everyt What's nice is that you could really adjust these however you want them. Different from any other side cover, ones that just bolt on, you can really, really fit these to each application. And your line will line up all the time. So, let'see if we can do t What we're going to do is, since I already marked them, what you do is place the covers on where you want them, hold them securely and screw two screws at the top and one screw at the side. When that's all said and done, what you're going to do is you're going to pull your side cover off. Alright, and you'll have the two markings right here and one more right there. Now, what you're going to do is just scuff these up real good. And with your panel bond, you're going to place it all over here. And then you're going to take your side cover once you do it. Actually, you're going to take all t Make sure you do that. Otherwise, you're going to make a mess. But those screw holes will give you a place where you got to do it and you'll line up every single time. So, t You can actually take it off. So, now what you'll do is you'll pop the covers off, grind down all the areas w And those are the areas that your glue will cover. And you're going to place your side cover back over it with all the glue. And you're going to take your screws and mount them right into your existing mounting points. That'll give you a perfect fit every time. And that's it. You're done. It's as simple as that. When you're all done with it, you can take the screws out, put a little filler on it, and you're good to go. That's it. Easy as that. Saves you a couple hundred bucks and you get a very, very custom fit. There's your lesson for today. I'm putting on side covers.
